GENESISL1 TUTORIALS

How to bridge L1.

Bridge wrapped L1 from Base to GenesisL1, then unwrap it into native L1. Follow the wallet prompts, wait for settlement, and verify the destination balance.

  1. 01
    METAMASK / BASEwL1
    START
  2. 02
    BRIDGEBASE TO GENESISL1
    TRANSFER
  3. 03
    GENESISL1NATIVE L1
    UNWRAP
  4. 04
    VALIDATORSSTAKED L1
    DELEGATE

Bridge wL1 into native L1.

Move wL1 from Base to GenesisL1 blockchain, then unwrap it into native L1. The bridge is non-custodial and uses the account selected in MetaMask.
OUTCOMENative L1 in your MetaMask-derived GenesisL1 account
YOU WILL NEED
  • MetaMask
  • wL1 on Base
  • ETH on Base for gas
STEP-BY-STEPOpen any screenshot to inspect it in detail.
01

Open the official bridge

Open the official GenesisL1 bridge and read the interface disclaimer. Confirm that the source is Base, the destination is GenesisL1, and the connected MetaMask account is the account that holds your wL1.

Connect MetaMaskOpen the official bridge and connect the MetaMask account that holds wL1 on Base.
02

Set the bridge direction

Choose Base to GenesisL1 and enter the wL1 amount. Keep enough ETH on Base to pay gas. For a first transfer, use a small test amount before moving a larger balance.

Set Base to GenesisL1Switch the route so Base is the source and GenesisL1 is the destination.
03

Approve and bridge wL1

Review the source network, destination network, recipient, amount, and wallet prompt. Approve wL1 if requested, submit the bridge transaction, and keep the transaction hash until the transfer finishes.

Submit the bridge transferEnter the amount, verify the destination account, and submit the bridge transaction.
04

Confirm arrival on GenesisL1

Wait until the bridge reports completion and wL1 appears on GenesisL1. Settlement time can vary with network conditions and bridge processing. Do not submit the same transfer again while the original transaction is pending.

Wait for settlementRefresh both chains until the transferred wL1 balance appears on GenesisL1.
05

Unwrap into native L1

In the bridge interface, choose the advanced action to unwrap wL1 on GenesisL1. Enter the amount, review the transaction, and confirm it in MetaMask. Unwrapping converts the wrapped representation into the native L1 coin.

Unwrap wL1 on GenesisL1Open Advanced, select Unwrap wL1, enter the amount, and confirm the GenesisL1 transaction.
06

Verify native L1

After confirmation, refresh the balances and verify that native L1 is available. Keep at least 1 L1 liquid for GenesisL1 transaction fees before you delegate the rest.

Confirm native L1Refresh the balances and confirm that native L1 is now available on GenesisL1.